The Ultimate Guide For Installing A Pump For Irrigation

Installing an irrigation pump for your garden or lawn in Australia allows you to keep your plants watered without spending time doing it manually. If you have a small irrigation system you can use the pressure of the water line to irrigate your plants. However, if you have a large system or water has to travel uphill, you will need to install a pump. Here are a few things you need to consider before installing your pump.

Estimate the pressure requirements

You should begin by estimating the flow and pressure requirements for your pump in Australia. Calculate the flow of the water in gallons per hour.

Choose the right pump

Choose a pump that is rated for the pressure and flow it will encounter in your irrigation system. Don’t forget the electrical connection needed to power the pump.

Connect your pump to the irrigation system

To avoid unnecessary irrigation pump repair in Australia, make sure the water supply connects to the inlet valve of the pump and irrigation system connects to the outlet. The threads should be covered on the connectors with a plumber’s tape before connecting the water pump to prevent leaks.

Install the pump relay controller

Mount the relay controller in a location where it is protected from direct sunlight. Connect the pump’s controller according to the instructions and connect both the pump and relay to your electrical system.

Test

Test the pump by turning on the water flow to the system and then turn on the pump. The pump should pump water through your irrigation system.

Things you need

For this to be successful, you will need a plumber’s tape, irrigation pump, water pressure gauge, outdoor electrical outlet, pump relay controller kit and electrical wire. If you do not have power outlets in Australia that are compatible with your pump, you should install one.